Attaching Hardwood Edge To Workbench

Question we are currently working on a project that has a large number of raised panels approximate size 36 x 96.

Attaching hardwood edge to workbench.

I currently have a large l shaped workbench i built using framing lumber and methods 4 4 posts 2 4 3 4 ply and i m getting ready to add additional layers to finish it off. I use a woodworking method s. I also want to be able to replace the hardboard when it gets too dinged up. Attaching hardwood edges to panels here s a handy tip.

I am building a workbench using two 3 4 in. Attaching hardboard to plywood workbench top. I m going to lay down another layer of 3 4 ply then a layer of either 1 2 or 3 4 finish ply on most of the table and the same thickness melanine on. I also wrapped the edges with red oak using glue and counter sunk screws to hold it in place.

Plywood pieces glued together for the top. Attaching hardwood edge to workbench top. If the depth of the edge is 3 to 4 inches on a 1 3 4 inch top then glue alone will be fine for strength on the sides with lots of clamps. Https amzn to 2h6irrm video about router table edge banding https youtu be hoqwcbng.

We need to glue hardwood edges to. Use pocket holes and screws for edging panels with solid wood and mate the pieces using tongue and groove joints. Attaching hardwood edge to workbench top. The long grain piece will not expand and contract with seasonal changes like the actual top i would fasten the end pieces in such a way as to.

Detailed video on how i build a table top and the clever way i attach it to the base without using any screws of metal hardware. The ends will be a different matter. However you will have a clamping problem on the ends unless you have extremely long pipe clamps. I want to attach a 1 4 in.

Hardboard masonite type to the plywood so i will have a smooth surface. If you decide to go with the 4 high border on the ends of bench note steven s caution on differential wood movement.