Attaching A Laminate Countertop To Cabinet

Apply weight to countertop or cut short flexible sticks to wedge between upper cabinets and countertop fig 5 to apply downward pressure taking care not to damage upper cabinet or countertop.

Attaching a laminate countertop to cabinet.

If the cabinets have no tops screw through the front rail and any blocks built into the cabinet. The screws should total 1 4 less than the combined thickness of the countertop substrate and the support rail on the cabinet. Press straight down and then slide your palms across the middle section of the laminate to join it. Before you attach your new laminate countertop to the base cabinets you might want to add extra support near the edges especially along the back.

The upper is a bookshelf attached to the countertop. Basically the lower that looks like a standard base cabinet with stretchers. This lip covers the base cabinet. The countertop edge is 1 1 2 wide so it hangs 3 4 down.

Add a decorative countertop edge that wraps all three sides front side side. Put a screw say every 16 24 inches or so. Attach the countertop by driving р 4 in long screws up through the 1x mounting blocks installed by the cabinet manufacturer see the illustration on the fac ing page. The countertop will hold itself in place so there s no need to riddle it with screws.

Construction is a two piece cabinet. Up to 4 1 4 in. Be sure to place pressure sticks along the back corners where the corner blocks are located to get the countertop down tight. It has an adjustable guide so you can cut strips ranging in width from 1 2 in.

Usually a 1 1 4 screw will do it. Drill through the buildup strips or add angle brackets inside your cabinets. Set them just below the top of the strips. A laminate slitter 140 at online retailers is almost a must for cutting thin laminate strips.

If you need to replace your countertops but want to avoid paying labor costs installing a laminate countertop may be the project for you. Cut any narrow strips first before rough cutting the large kitchen countertop pieces. Then drive the screws in from underneath. Available in a variety of colors textures and patterns you can find laminate counters to fit any design style from traditional and farmhouse to urban and contemporary.

Wipe up any squeeze out and allow to dry according to adhesive manufacturers specifications. Position the countertop starting with the longest piece. Place your palms in the center of your laminate and slowly press down until you ve touched the laminate to the countertop. Place pressure sticks every 12 to 18 inches to help the adhesive bond the countertop to the cabinets at the back edge and apply clamps to the front edge.

Seal the seam between the backsplash and the wall with silicone caulk that matches the color of the countertop.